The MultiPlus is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure. Models range from 800VA to 5000VA per module.
Unique PowerAssist feature
The MultiPlus will prevent overload of a limited AC source. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.
Uninterrupted AC power (UPS function)
In the event of a grid failure or shore or generator power being disconnected, the inverter within the Multi is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.
Virtually unlimited power thanks to parallel operation
Up to 6 Multis can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible. Please check our datasheets to see which models have paralleling, three-phase and split phase capabilities.
6v Trojan battery T105, 225ah
Manufactured by Trojan, the market leader in quality Deep Cycle manufacturing
Consumer and trade recognised brand
6 Volt (220ah @ 20hr rate - 180ah @ 5hr rate)
26 kg - 264mm length x 181mm wide x 276mm high
Terminals available as M8 stud LPT
|Capacity (C5)||185 Ah|
|Capacity (C10)||207 Ah|
|Capacity (C20)||225 Ah|
|Capacity (C100)||250 Ah|
|Height inc. terms||281 mm|
This product has Cheaper Delivery to Business addresses.
These panels have a glass back sheet so they absorb sun which bounces back from behind the panel. Great for low light and cloudy conditions. These are ideally suited to boats with a white roof as you can see gains of upto 26% from the reflection of light back from the white surface making the panel 491W. Any surface will work, but white gives you the best refraction of light back to the panel, or you can add aluminium solar reflective paint on the roof under the panel to get the best gain.
If using this panel with MPPT you should calculate this panel as 500W so that you do no overload the MPPT. Tracer MPPT's have current limiting so it doesn't matter if you go over the rated amps, but Outback will be damaged by too much power.
The LG NeON® 2 BiFacial is designed to absorb irradiance not only from the front but also the rear of its NeON® cell by using a transparent back sheet. The dual face of the cell allows for higher energy generation.
Thanks to a combination of highly efficient bifacial n-type NeON® cells with Cello technology, which replaces traditional 4 or 5 busbars with 12 thin wires, LG NeON® 2 BiFacial modules can achieve up to 30% more energy than standard PV module.
Enhanced Performance Warranty
LG NeON® 2 BiFacial has an enhanced performance warranty. LG NeON® 2 BiFacial is guaranteed at least 86% of initial performance after 25 years.
Bifacial Energy Yield
LG NeON® 2 BiFacial modules use highly efficient bifacial solar cell with Cello technology..Through the Cello technology, LG NeON® 2 BiFacial can achieve up to 30% more energy than monofacial modules (under optimal conditions)
Better Performance on a Sunny Day
LG NeON® 2 BiFacial now performs better on sunny days thanks to its improved temperature coefficient.
More Generation on a Cloudy Day
LG NeON® 2 BiFacial gives good performance even on a cloudy day due to its low energy reduction in weak sunlight.
BOS (Balance Of System) Saving
LG NeON® 2 BiFacial can reduce the total number of strings due to its high module efficiency resulting in a more cost effective and efficient solar power system.
Near Zero LID (Light Induced Degradation)
The n-type cells used in LG NeON® 2 BiFacial have almost no boron, which may cause the initial efficiency to drop, leading to less LID.
This listing is for 1 panel, simply select how many you need in the quantity. There is NO MINIMIUM Order.
Get 5% discount for Cash On Collection Payments
Delivery from £24+vat
First panel £24+vat, each additional panel just £6+vat delivery
ie: 3 panels costs £36+vat delivery.
Delivery service is an economy service that hand delivers fragile items on a weekly round across the UK.
Surcharge for remote areas including parts of Wales, Scotland, Ireland and Isle of Wight, please see Delivery info
This is a safer more reliable and cheaper way for you to receive panels and saves on the huge amounts of wasted packing materials.
Pallet Shipping 25 panels per pallet:
£175 UK Mainland
£375 Rest of Europe
Or you can collect for FREE from Nr Brighton.
New XTRA series - 3rd Generation MPPT
For 12V Solar System: 520W solar panel (150V for max input voltage)
For 24V Solar System: 1040W solar panel (150V for max input voltage)
No Fan for silent operation, great for vans, boats or any live in spaces
With built in LCD advanced display and programming screen (XDS2)
New XTRA series has Lithium battery support (set via PC cable only)
The XTRA tracer models have a current limiting function, you can connect twice the rated power to the controller so if your on a budget you can use a smaller controller with more panels so that you get more power in winter or low light but don't risk overloading the controller in the summer. The output will be limited to the max listed above.
New EPEver (Tracer) series is EPsolar’s third generation of MPPT controller.
XTRA series are advanced maximum power point tracking (MPPT) charge controllers, for off grid photovoltaic systems, with display unit.
In order to maximise the energy harvest from PV arrays and simultaneously minimise the power loss within a wide range of operating conditions, XTRA series apply an advanced smart algorithm which results in up to 30% higher efficient charging, compared to a conventional pulse width modulation (PWM) charge controller. Xtra series controller have limit protection function on charging current &charging power, as well as auto derating power operation at high temperature; the above protection ensure the stability of system even at exceeded rated PV power and over temperature conditions.
Protection class IP32 and isolated RS485 communication port further improve the controller’s reliability under different application requirements. XTRA series controllers incorporate a self-adaptive three-stage charging algorithm based on a digital control circuit, which eeffectively prolongs the lifespan of battery and significantly improve the system performance. It also has extensive electronic protection for overcharge, over discharge, PV&battery reverse polarity and etc. to ensure the sustainability and durability of the o-grid solar system.
¹ If using Lithium battery, customer should use “PCsoftware” to set the lithium battery parameters
² Ingress of solid objects:Protected against solid objects over 2.5mm
² Ingress of liquids: Protected against falling drops of water, if the case is disposed up to 15 from vertical
A pair of 2mm stainless steel (316L) solar panel brackets designed with canalboats and vehicles in mind, supplied with marine standard cable glands and anti tamper bolts & bit.
Allow your solar panels to both tilt and swivel throughout the year, maximising the sun's energy whilst providing excellent ventilation. This can improve the power of your panels by up to 40%, perfect for smaller systems where efficiency is key. *Standing at just over 25cm high and 16cm wide they're designed to maximise the angle of your panels whilst being low enough for most bridges and tunnels.
Using any padlock attach your panel securely to the roof via an integrated 8mm stainless steel chain that secures directly to the bracket, keeping your panels safe. The anti tamper bolts secure the bracket to your roof for maximum security deterring even the most determined of thieves.
Using M10 for both bolts and glands means you only need to drill six identical holes, saving both time and money on tools or labour whilst providing a safe and secure mounting solution.
A tool kit with everything you need for a waterproof and secure installation supplied separately, select the tool kit option to purchase this as well.
2 top spec cobalt drill bits and M10 tap and ratchet allow quick and easy installation with even the toughest steel roof. Supplied with marine sealant and instructions, a secure and waterproof installation can be done in as little as 4 hours.
50mm Cable - Use for connecting Batteries to Inverter
You will need 2 cables, 1 for Positive and 1 for Negative
If you need a longer cable please let us know.
6mm Solar Cable - Price is per meter simply select the quantity as the number of meters you want.
Double Insulated UV protected solar cable
Max load: 50A
Save yourself hours of drilling! Get our essential toolkit for installing the boat swivel mounts!
Cobalt drill bits (for drilling into the panel frame and boat hull) 8.5mm and 5.5mm
Ratchet and Tap
Battery Inter-connecting Cable - 35mm cable with M8 - M8 Lugs (M8 on both ends)
Made up to size for you for connecting your batteries together.
400A Fuse for 12v or 24 systems - Pack of 5 fuses
For use with Mega Fuse Holder
Optional Meter for AN BN & CN Tracer MPPT charge controllers (10A, 20A, 30A or 40A) for CN controllers need specialist cable cable available on our site
PLEASE NOTE - YOU CANNOT USE THE MT50 AT THE SAME TIME AS THE BLUETOOTH / WIFI OPTIONAL ADAPTORS
·Automatic identify the controller, and display the type, model and relevant parameter data
·Large-screen multifunction LCD displays all the operational data and system working status in digital, graphic and textual forms
·With six navigation function keys, the operation is direct, convenient and rapid
·Real-time energy statistics recording
·Both data and data flowing on the same lead ,no need for external power
·Real-time monitoring and acoustic alarm of failure information of the controller
·Longer communication distance based on RS485
Functions Via MT50
·Diversified load control modes : manual, light ON/OFF, Light ON+ Timer, Time Control
·Battery type selection: Gel, sealed, flooded and USER type
·Energy display function
Backlight and acoustic alarm on<65mA
Backlight off <15mA
98×98 mm / 3.86×3.86 in
114×114 mm / 4.49×4.49 in
Standard 2m, max .50m
Mega Fuse holder for the Victron Mega Fuses. Interlocking cases so you can neatly mount multiple fuse holders together.
With one M10 input connection. Input current up to 500 A.
Cable Gland Entry Box, use to connect through external surface. Perfect for solar panel cables coming from outside to controller.
Affordable DC Breaker for 35mm DIN mount. Use with our DIN Rail as an easy and affordable breaker solution.
Current Flows from top to bottom of the breaker:
For charge controller wire top pole to charge controller and bottom pole to battery.
For Inverter wire top pole to battery and bottom pole to inverter.
MC4 Solar Connector - Price is per MC4 pair simply select the quantity as the number of MC4 pairs you want.
These are the standard connectors used on most solar panels.
TUV certified, brand new, water /weather proof rubber seal that can ensure excellent electrical contact for life time service.
The metal pin is made from high quality machined copper and sealed tip (compare to the cheap sheet metal pin) that can ensure excellent electrical contact for life time service.
Build in press tabs for easy disconnect, no tool is needed. 25A max load.
Wires should be crimped or soldered into the pins and care should be taken to get the correct pin into the correct connector. Once the pin is pushed into the connector it is difficult to remove without the correct tooling.
MC4 Main Technical Specification:
Maximum Current: 25A
Maximum voltage: 1000V
Maximum operating humidity: 5% -95% (No condensation)
Temperature: -40 ℃ ~ +90 ℃
Waterproof Grade: IP67
Flame class: UL94-V0
Connecting cable specifications: 2.5mm2 4mm2 6mm2
Test voltage: 6.6KV (50Hz, 1min)
Metal materials: nickel copper
Insulation material: PA12 * 1988HB
Lock mode: Self-locking
Security Level: Class ‖
Shell has a strong anti-aging, anti- UV capability; found in outdoor use under harsh environment requirements; according to different needs can be arbitrary and used in conjunction with a variety of cell junction box; all connections are using press-fit connection;
Simple DIN mount rail 10cm long for DC or AC DIN mount breakers. Easy solution, simply screw the rail to the wall of your electrical installation and connect the breakers to it. Quick easy and simple solution to install breakers to your solar system.
Use with our: