Further items for a solar installation on our boat. Everything was well packed and arrived quickly and safely. I'm once again a very happy bunny, lol! Cheers Bimble Solar, 10 out of 10, excellent service indeed! Very many thanks
Just easy and simple to deal with - great seller...
Laura was really really helpful when I asked for some help. I got an order together and it arrived really quick. Great service.
Voltage Sensing relay for modern engines with smart alternators for Euro5 and newer engines.
The Durite smart relay capabilities now allow for use with the latest range of vehicles fitted with smart alternators and regenerative braking systems
12 Volts, 200A Capacity.
Microprocessor control with 9 available programmes.
Manual override function
Suitable for split charging or battery saving duties
Warnings and Instructions for Translation Purposes
Before using this unit please read these instructions carefully.
Take special care to follow the warnings and safety suggestions listed below. Keep these instructions for future reference.
There are no user-serviceable parts within the unit, refer servicing to qualified service personnel.
The Durite Smart Relay has been designed to be used with the latest range of vehicles fitted with smart alternators and regenerative braking systems. ln addition, there are 9 available programmes allowing the user to set the charging/protection voltages to suit their requirements. Therefore, the Smart Relay is suitable for use either for charging of a secondary/accessory battery or for protection of the main battery from a particular high drain circuit. Additionally, it has the facility for a manual override allowing both batteries to be used to start the engine or to make safe a piece of equipment on the protected circuit before power is lost.
Terminal 30 to main battery +12V
Terminal 87 to a secondary battery or separate circuit +12V
Terminal 85 to ground or -0V
Terminals 86 is used for programming or override function
Connect terminal 86 through a momentary switch (not supplied) to terminal 30.
When the switch is operated and the circuit is made the unit will make the connection between terminals 30 and 87 for 30 seconds from when the switch is released.
To enter programming mode, the power must be off to terminal 30 and terminal 85 must be connected to ground or -0V.
Connect terminal 86 to terminal 30 and then re-connect the power to terminal 30.
The LED on the top of the unit will flash a number of times indicating the current programme number (once for 1, twice for 2, Etc.).
Remove and replace, within 40 seconds, the connection to terminal 86 and the LED will start to sequence through the programme numbers (once for 1, pause, twice for 2, pause, Etc.).
When the number of the programme required is reached remove the connection to terminal 86.
The LED will flash the number of times to confirm the programme number selected. if this is OK re-connect terminal 86 and the LED will flash quickly indicating that the setting is saved. (if not OK turn the power off and start again.) Turn the power off.
When the power is turned back on the unit will use the last programme set.