Backup only generator - this is designed as a back up only generator and not for running all the time

Auto Start
This generator can be auto started from a relay.  This can be used from systems like Outback MPPTs and inverters.  You can also wire a relay from the load terminals of a tracer.

To auto start wire a relay triggered from the charge controller or inverter into to back of key start system.  This has 3 wires, wire the start and run wires together and join to 1 terminal to the switch side of the relay, and the remaining wire to the other terminal of the switch side of the relay.

Product Description

* High efficiency and low noise of the direct injection combustion chamber
* The air intake and outlet pipe is separated, which avoids the turbulence, resulted in more smooth air cycling
* Thinner insulator of KIPOR silent generator which have stronger ability of resisting noise

FEATURES

Unique & Compact Structure
The generator set has a compact and unique design. The exhaust is ducted out from the top cover facilitating installation. The layout of the oil and coolant inlet has been redesigned to permit easier access for service.

Low Noise Running
The Kipor super silent generator series offer unparalleled low noise levels. Kipor applies a unique double air inlet and outlet design. The generator is equipped with a built-in large sound attenuating muffler and additional sound insulation liners to limit noise.

Digital Control Panel
The DC generators can be paralleled together with two or more, without limitation on model or number. Appropriate power capacity and number of paralleling units can be selected to meet different loads.

High Quality Power Output
The improved AVR (Automatic Voltage Regulator) limits voltage fluctuation to a very low level and ensures smooth and steady output. Additionally, the AVR features built-in overload protection and will automatically shut off the output at 110% of rated load.

Competitive Economic Advantage 
The high efficiency combustion system is designed to reduce fuel consumption and operation costs.

ATS (Automatic Transfer Switch)
ATS continually monitors utility power and voltage/frequency fall below acceptable levels. It commands the generator to start automatically and connect generator power to the intended load. Once proper utility power is restored, the ATS stops the generator and reconnects utility power. The ATS has been designed to be installed either inside or outside the generator set.

Working Out Wattage Requirements

For each appliance, identify how many watts it requires and then add 20% for resistive loads or add 50% for inductive loads.

Identifying Load Types

Resistive loads have no moving parts (e.g. kettles, light bulbs and heaters). Inductive loads have moving parts (e.g. motors, air compressors and pressure washers).