295W JA Solar Panels Mono Percium - All Black

Percium Cell
The latest in mono cell technology with passivated backside, local BSF and 4 Bus Bars from worldwide PV Cell leaders - JA Solar
First to reach >20.6% average cell efficiency in mass production
 
More Power Per m²
JA higher efficiency module type specially designed for UK rooftop market.
Maximise the kWp installation on the roof 
 
Aesthetics
Homogeneous Black Mono cells.
Black Frame for anti-glare and pleasing appearance.
 
Lower System Cost
Reduced installation and BOS cost
 
Excellent Low-light Performance
Enhanced spectral response at longer wavelength boosts low-light performance, which can produce more than 1% additional power compared with conventional module at system side.
 
High Reliability
Passed "3xMCS" TÜV SÜD Thresher Long life Accelerated Stress Tests.
Full range of PID-resistance tests
Harsh climate environment endurance tests
Full set of long-term reliability tests
Manufacturing inspected and certified by leading institutes such as PI-Berlin, Franhoeffer, Sgurr, OST and Solar-IF
100% in-house automatic manufacturing
2X 100% EL inspection ensuring defect-free production
Over 500MWp of JA Solar panels installed in the UK. 10GWp Worldwide.
 
Other Features
Positive power tolerance: -0~+5W
Modules binned by current to improve system performance
Excellent mechanical load resistance: Certified to withstand high wind loads (2400Pa) and snow loads (5400Pa)

Download Full Specsheet

Download Datasheet

Pure sinewave output, high peak power and high efficiency. Combined high frequency and line frequency technologies ensure the best of both worlds. Models range from 150VA to 3000VA per module.

Scalable: up to six Phoenix Inverters 3000 can be paralleled in single phase, split phase and three phase configuration.

Click Here for Full Datasheet

Click here to Download Owners Manual

Battery Inter-connecting Cable - 35mm cable with M8 - M10 Lugs (M8 on one end M10 on the other)

Made up to size for you for connecting your batteries together.

6mm Solar Cable - Price is per meter simply select the quantity as the number of meters you want.

Double Insulated UV protected solar cable

Max load: 50A

Use these to connect your battery banks so that the load is spread better and your batteries will last longer.  You will need 2 per bank, 1 for Positive and 1 for Negative.  We have an example of how to wire these on our instlation diagrams page

We can make them as 5 way or 7 way if you prefer.  Please specify this when you order if you want a smaller one.

Here is an example of wiring your batteries using the bus bar:

Fixed Key Battery Isolator Switch

High quality metal body, Durable plastic handle

300AMP continuous
1,000AMP for up to 10 seconds

Measurements
Body: 67mm Diameter, 100mm length
10mm studs

Battery Inter-connecting Cable - 35mm cable with M10 - M10 Lugs (M10 on both ends)

Made up to size for you for connecting your batteries together.

MC4 Solar Connector - Price is per pair simply select the quantity as the number of pairs you want.

These are the standard connectors used on most solar panels.

TUV certified, brand new, water /weather proof rubber seal that can ensure excellent electrical contact for life time service.
The metal pin is made from high quality machined copper and sealed tip (compare to the cheap sheet metal pin) that can ensure excellent electrical contact for life time service.
Build in press tabs for easy disconnect, no tool is needed. 25A max load.
Wires should be crimped or soldered into the pins and care should be taken to get the correct pin into the correct connector. Once the pin is pushed into the connector it is difficult to remove without the correct tooling.
 
Main Technical Specification:
Maximum Current: 25A
Maximum voltage: 1000V
Contact resistance:≤5mmΩ
Maximum operating humidity: 5% -95% (No condensation)
Temperature: -40 ℃ ~ +90 ℃
Waterproof Grade: IP67
Flame class: UL94-V0
Connecting cable specifications: 2.5mm2 4mm2 6mm2
Test voltage: 6.6KV (50Hz, 1min)
Metal materials: nickel copper
Insulation material: PA12 * 1988HB
Lock mode: Self-locking
Security Level: Class ‖
Insertion force:≤50N
Withdrawal force:≥50N
 
Features:
Shell has a strong anti-aging, anti- UV capability; found in outdoor use under harsh environment requirements; according to different needs can be arbitrary and used in conjunction with a variety of cell junction box; all connections are using press-fit connection;

16mm cable - for Large Charge Controller to Batteries - 2 Meter leght with M8 Lug

You will need 2 cables per charge controler (Pos & Neg).  The Lugs are on 1 end only as the charge controllers have bare wire connectors.

If you need longer lengths please let us know

16mm cable - for Large Charge Controller to Batteries - 2 Meter leght with M10 Lug

You will need 2 cables per charge controler (Pos & Neg).  The Lugs are on 1 end only as the charge controllers have bare wire connectors.

If you need longer lengths please let us know

35mm Cable - Use for connecting Batteries to Inverter

You will need 2 cables, 1 for Positive and 1 for Negative

If you need a longer cable please let us know.

35mm Cable - Use for connecting Batteries to Inverter M8 - M10 (M8 one end M10 on the other end)

You will need 2 cables, 1 for Positive and 1 for Negative

If you need a longer cable please let us know.