Great service. Very helpful and quick to respond. I will definitely be using bimblesolar in the future
They say "perfection is the pinnicle of excellence"
I am sorry, I cannot offer any higher input to improve the service at BIMBLE SOLAR as the team has it down to a fine art.
Fantastic, efficient and helpful, and great kit at great price point. Excellent at every step of the way. I ordered 4x 150 watt flexible solar panels from them plus an MPPT charge controller and various wire bits etc to set it up, all for a motorhome off grid set up. The panels were the best value I could find on the internet. Their website's suggested bundles were helpful for getting what I needed. They didn't stock the exact MPPT I wanted but found it for me and provided it at a competitive price. Deliveries were extremely prompt. One of the panels was defective and they arranged a hassle free pick up and replacement without complaint. They answered questions both pre and post sale including patiently helping with quite complicated stuff and trying to problem solve things, including some long technical phone conversations before I'd bought anything. The panels I have received are capable of more than 100% of their rated wattage output, in ideal conditions including angling them correctly towards the sun! Just a great experience all round.
We can price match or beat any supplier, do get in touch.
Pre-Programming, we can program your system to save you time & money.
Pre-made Boards, we offer mounted and wired van electrical boards also custom pre-built off grid electrical boards to any size.
Extended Victron Warranty is available 10% surcharge 5 years to 10 years.
Contact us 01273 931110 or firstname.lastname@example.org for any of the above.
The Victron BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.
Programming made easy
The BatteryProtect can be set to engage / disengage at several different voltages. The seven segment display will indicate which setting has been chosen.
A special setting for Li-ion batteries
In this mode the Battery Protect can be controlled by the VE.Bus BMS.
Note: the Battery Protect can also be used as a charge interrupter in between a battery charger and a Li-ion battery. See connection diagram in the manual.
Ultra low current consumption
This is important in case of Li-ion batteries, especially after low voltage shutdown. Please see our Li-ion battery datasheet and the VE.Bus BMS manual for more information.
Over voltage protection
To prevent damage to sensitive loads due to over voltage, the load is disconnected whenever the DC voltage exceeds 16V respectively 32V.
No relays but MOSFET switches, and therefore no sparks.
Delayed alarm output
The alarm output is activated if the battery voltage drops below the preset disconnect level during more than 12 seconds. Starting the engine will therefore not activate the alarm. The alarm output is a short circuit proof open collector output to the negative (minus) rail, max. current 50 mA. The alarm output is typically used to activate a buzzer, LED or relay.
Delayed load disconnect and delayed reconnect
The load will be disconnected 90 seconds after the alarm has been activated. If the battery voltage increases again to the connect threshold within this time period (after the engine has been started for example), the load will not be disconnected.
The load will be reconnected 30 seconds after the battery voltage has increased to more than the preset reconnect voltage.