Lorentz S1-200 pump for use with just 1 Solar Panel - HR-07 Max. flow rate 1 m³/h     Max. head 40 m

Lorentz S1-200 pump for use with just 1 Solar Panel - HR-07 Max. flow rate 1 m³/h     Max. head 40 m
List Price: £692.31 +vat
£810 (including VAT and 2.5% off for bank or card payment)
Pay Monthly Finance on orders from £2k - £30k
Availability: 5 - 10 Days
 
ID: 3103
Lorentz S1-200 pump for use with just 1 Solar Panel - HR-07 Max. flow rate 1 m³/h     Max. head 40 m Lorentz S1-200 pump for use with just 1 Solar Panel - HR-07 Max. flow rate 1 m³/h     Max. head 40 m

Accesories: Lorentz S1 Dry Run Protection Switch   Lorentz S1 Tank Full Switch    Motor Extension cable    Lorentz accesory Extension Cable

Made in the Germany, Lorentz S1-200 pumps are extremely robust 

and designed to run from just 1 solar panel.

     

  • Self install, solar powered water pumps for drinking water, livestock or irrigation

  • Robust and reliable for permanent installation, but also easy to transport and move 

  • Energy, cost and carbon saving giving you independence from the grid 

There are three pump variants that cover the range of head and flows.

  • HR-23 Max. flow rate  3 m³/h    Max. head 17 m [55 ft]

  • HR-14 Max. flow rate 1.9 m³/h  Max. head 30 m [100 ft]

  • HR-07 Max. flow rate 1 m³/h     Max. head 40 m [130 ft] THIS LISTING

  • LINK - Click here for pump calculator tool link 

Data provided is the annual daily average based on using a single 375 Wp PV module at location 15N 0E.


Installation note:

If you have a borehole cover (or similar) with a set hole cutout to put in the motor cable, the Outside Diameter of the motor connector is 30mm, as long as the connector goes through the hole it can then be sealed by using a "split gland", splitable gland / divisible gland.  These are split to go around the cable and allow you to install without removing the plug.  If the hole is not big enough (25mm) then cut a bigger hole (32mm) and install a split gland.