If you have a trapezoid box framed steel roof then thhis is the most affordable and simple way of mounting your panels.

The clampfit keep the panel nice and flush to the roof with no need for bulky expensive roof rails.

Just check out the installation video to see how simple these are to fit, see link  installation video

2 MID clamps for one long side panel in landscape orientation only (must be used in conjunction with Clamp Fit Mid clamps)

The Schletter ClampFit Pro Modular bundle is a simple and cost-efficient solution for mounting a single PV panel in landscape on a trapezoidal metal roof that has a minimum thickness of 0.5 mm.

• Less storage space required
• Quick to install
• Minimum trapezoidal beading height: 34mm
• Maximum trapezoidal pitch 45°

• Module clamps suit a panel with a module frame thickness from 30mm up to a maximum of 47 mm.
•  2 Screws (SCH-943000-360) included per Clampfit Pro

Please see installation video

This is for use with Proline module clamps only

You must use at least 4 module clamps for one solar panel ( 2 mid clamps included). For example two solar panels one above the other in landscape would required 6 Clamp fit, 2 mid clamps and 4 end clamps (please see related products tab).

Although typically this system will use 4 fixing points per module. At high wind or snow loads or with large modules it may be required to use 6 fixing points for extra safety.

Contents

2 x ClampFitPro (130004-300)

4 x Drill screw (943000-360)

2 x Mid clamp RapidPro 30-47mm (131020-001)