Always good; new website works well; informative, tech support when needed, recommend highly
Great advice from start to finish, great products and prices. Highly recommended.
I have been a customer of Bimble Solar for around 10 years. My farm is off grid, so I am totally reliant on my outback system performing reliably. Even the most robust systems suffer with problems and Bimble have always managed to source me the parts or replacements in double quick time to ensure minimum disruption. I purchased a replacement inverter many months ago and did not have time to commission the unit. When I eventually found the time to commission the new inverter, I was faced with a very challenging situation, as the new VFXR unit I purchased was not compatible with my existing stacked VFX 3048E system. I contacted Anthony at Bimble to see what my options were as my system is a stack of 3 units and replacing the full system was not really a viable option for me. Bimble went above and beyond what could ordinarily have been expected and tracked down a brand new VFX3048E unit from somewhere in Europe, arranging for it to be delivered and exchange for my incorrectly purchased VFXR3048E unit. All I can say, is that it is a truly outstanding way to deal with customers and they will always retain my custom whilst providing such a high level of customer service.
The Renusol ConSole CS+ buckets are a ballasted solution for installing PV modules on flat roofs or the ground.
Please note, Max module width 1015 mm (generally solar panels under 400w)
The ConSole+ provides an angle of 15 degrees and can be fitted to flat roofs with a pitch of up to 5 degrees. Many commercially available framed PV modules fit on the ConSole. Please check the Console CS+manual for the panel dimensions and panel mounting hole centres and compare this to the solar panel data sheet.
The ConSole is weighed down with ballast. Any material can be used: gravel, paving slabs, bricks, rocks etc. The amount of ballast depends on the height and location of the building. Please see Page 5 of the installation manual "Preparing the Assembly - Point 2" in the table.
Mounting components are included for framed PV-modules. The modules attach to the mounts using the mounting holes on the back of the module. Please check the measurements below against your panel specification:
Max module length: 1550-2150 mm
Holes gap - width: 895-1014 mm
Holes gap - length: 690-1180 mm
1 x ConSole+
2 x ConSole U-Profile 1035 mm
4 x Hexag screw DIN933-M6x20 A2-70
4 x Washer DIN9021-6,4-A2
4 x Self-locking hexag nut DIN985-M6-A2
4 x ConSole Clip
4 x Hexag screw DIN7504-ST5,5x25-A2-SW8